Trombley v. McAfee
Trombley v. McAfee
Opinion of the Court
The plaintiff brings this action to recover from the defendants damages for an injury sustained by him on March 16, 1906, while in defendants’ employ in a heading mill at Mantón, the injury resulting in the loss of both his right arm and his right leg. The plaintiff, a man about 30 years of age, was employed to cut the heads of barrels in a machine called a turner. The defendants employed 30 to 35 men in the mill, the room in which plaintiff was employed being about 30 feet in length, north and south, by 20 feet in width, east and west, the ceiling being 8 feet in height. In addition to the turner, the room contained a planer, a jointer, and a buzz planer. The line shaft extended the full width of this room in the north part, about 6£ feet from the floor, and on it were four tight pulleys driving the turner, the planer, the jointer and the buzz planer respectively. The turner was located in the southeast part of the room about 20 feet from the line shaft, and connected with it by two belts, one extending from the turner to an intermediate counter-shaft, and the other from such counter-shaft to the line shaft. There was also on the counter-shaft a loose pulley at the east end. The counter-shaft was If inches in diameter and 3\ feet in length, suspended from two iron hangers about 7\ feet from the floor. The office of the loose pulley was to stop the. machine with which it was connected without stopping the other machinery in
The defendant George McAfee was the superintendent, general manager and foreman of the mill, and at different times while plaintiff was employed, the defendant Andrew McAfee, his son Don and one Henry Orcut, millwright, acted as foreman and gave directions. The plaintiff’s testimony tended to show that he had no authority over any others in the mill, and that his duty was to turn out heading in the quality and quantity desired.
The testimony offered on behalf of the plaintiff tended to show that the loose pulley in question was out of order and had been for a considerable time; that it rattled so as to cause apprehension that it might fly loose from the shaft and cause injury; that plaintiff was directed to babbitt it so as to make it tighter on the shaft; that he did this a few days before the injury occurred to him. In babbitting the pulley onto the shaft, the plaintiff evidently got it too tight and the defendant George McAfee took a sledge hammer and broke it off. Another pulley with three-inch bore was tried, but that didn’t work, according to the testimony of the plaintiff, for the reason that the belt would not stay onto the loose pulley, but would come back onto the tight pulley as before. There was no belt shifter. It appears that a belt shifter serves two purposes, one to make the actual shift of the belt from the tight to the loose pulley, and the other to hold the belt in position after it is shifted.
It appeared that something like a year before the injury, a worm feed to the machine operated by plaintiff wore oüt, and a new one was sent for. In order to operate the machine until the new appliance reached them, defendants put in an independent counter-shaft over the header and drove it directly from the main line shaft by
■ There was testimony from which the jury might have inferred that in the absence of a shifting device which would hold the belt to the loose pulley, and in view of the testimony of the plaintiff that the belt would not remain on the loose pulley which was on the shaft at the time, it was a proper method to throw the belt off the main line pulley and loop it up to hold it away from the shaft. There was testimony that the plaintiff had been accustomed to do this, and at first he had required the engine to slow down when he wanted to' throw the belt off the main line pulley, but that the defendants ordered the discontinuance of that practice and told plaintiff that he must throw the belt while the machinery was in motion, and that thereafter the practice was to throw it without slowing down.
On the day in question, the plaintiff had placed a barrel near the shaft, had stepped up on the head of the barrel, had thrown the belt off the main line pulley, and was in the act of fastening it up with a string to keep it from burning from the motion of the shaft, when he became involved with the shaft and was seriously injured. The declaration avers that the manner in which he became involved with this shaft was by being caught with the frayed ends of the rope which had been used in making the rope pulley, which frayed ends were hanging down, and of which plaintiff was ignorant, and which he could not see
The theory of the plaintiff is that, as the statute, section 8 of Act No. 113 of the Public Acts of 1901, defining the duty of factory owners, provides that the “belting shall be provided with proper safeguards, and wherever possible machinery shall be provided with loose pulleys,” this statute required that the employer, in the exercise of the duty of providing loose pulleys, shall observe a reasonable degree of care, and shall provide one reasonably fit for use; that a failure in this regard is negligence per se; and that the employé does not assume the risk resulting from the violation by the employer of a statutory duty imposed for the employe’s protection.
It is further contended by plaintiff and appellant that, the defendants having increased the ordinary risk of doing the work, the duty rested upon them of informing the plaintiff of the increased risk, and that, the defendants having placed this rope on the shaft and left it there, plaintiff could defer to their implied assurance that no unusual danger would be occasioned thereby.
The defendants, on the other hand, assert that the plaintiff knew that there was no shifter,. and that the necessity for making use of the other method of looping up this belt was occasioned not because of the inadequacy of the loose pulley, but because of the want of a shifter ; that the pulley would have answered its purpose had there been a shifter performing the office not only of shifting the belts but of holding the belt on the loose pulley after it was placed there; and that as there is no testimony tending to show that the shifter was required by the factory inspector, negligence cannot be imputed to the defendants, as a matter of law, for failure to provide such shifter.
The question remains as to whether there was any testimony from which the jury would have been justified in inferring that contact with the loose ends of the rope was what in fact caused the injury to the plaintiff. Plaintiff’s testimony upon this point we quote at length:
“When I got up there I intended to loop the belt off the shaft.
ilQ. And what did you do ?
“A. I reached for it and got caught by the hand.
“Q. Which hand did you reach ?
“A. My right hand.
“Q. Did you get hold of the belt ?
"A. No, sir, I didn’t.
“ Q. .How close to your hand did the belt get ?
“A. I got just about touching it, I should judge.
“Q. You say you should judge that your hand had almost reached the belt ?
“A. Yes, sir.
“A. I got caught by my right hand.
“Q. What caught you ?
“A. The rope.
“ Q. Well, what happened to you ?
“A. I went around the shaft. * * *
“ Q. Now, you say when you reached over for the belt • something caught your hand ?
“A. Yes, the rope caught my hand.
“ Q. How do you know it was the rope ?
“A. Because I felt it, felt something take hold of me, I felt it catch me; it jerked me quicker than I had time to jerk.
“ Q. How could you tell in that instant of time by the feeling that it was the rope that caught your hand ?
“A. Well, I felt it catch me — I knew it was the rope.
“ Q. Well, that was your opinion, that you got caught by the rope ?
“A. Nothing else could catch me there.
“ Q. That is what makes you think it ?
“A. No, I felt it grab me, whatever it was, and I know it was not the belt because I wasn’t near enough to it, and I felt it pull me and it fetched me up against the pulley and broke my ribs.
“ Q. But you don’t think it was the belt ?
“A. No, because I hadn’t got hold of the belt yet; I was just reaching for it.
“ Q. Well, had you got hold of the rope?
“A. Which rope ?
“ Q. That rope on the shaft; you say you hadn’t got hold of the belt yet, had you got hold of the rope ?
“A. No, the rope got hold of me.
“ Q. That is what made you think about it ?
“A. Yes, sir. I know.
“ Q. Did you see the rope then ?
“A. No, sir, or else I wouldn’t have put my hand there.
“ Q. But you knew it was there ?
“A. Yes, sir.”
This testimony, when taken in connection with the testimony of other witnesses, that the ends of the rope were at times swinging away from the shaft, we think, leaves it open to the jury to find that it was such extended end of the rope that caught the plaintiff’s hand. It is true that the word “rope” as used in this extract might have
If the plaintiff, in adopting this method of tying up the belt, was required to do so because of defendants’ failure in the performance of a statutory duty, or their failure in providing other adequate means of putting his machine out of commission, and this with the knowledge of the defendants, it certainly cannot be said that he assumed any risk not reasonably obvious to him at the time. It is true that any act of contributory negligence would still constitute a bar to plaintiff’s recovery. But the question of whether he had knowledge that this rope pulley had in fact thrown out ■ these strands, or whether he should reasonably have apprehended such a condition, would be a question for the jury. Clearly, if he did know, or if as a reasonable man he should have apprehended such a condition, he would be guilty of contributory negligence in getting within reach of these while tying up the belt. If he did not, the question of whether he acted with reasonable prudence would be likewise a question for the jury.
The judgment is reversed, and a new trial ordered.
Reference
- Full Case Name
- TROMBLEY v. McAFEE
- Status
- Published