Goulds v. Brophy
Can I rely on this case?
Citation treatment has not been reviewed for this case. The notes below come from the citation graph and the Minnesota Revisor's amendment records, not from a review of how later courts treated this decision.
(as of 9/30/2026)
Last cited by a Minnesota appellate court in 1958, among the opinions in this site’s citation index.
Not a substitute for Shepard’s or KeyCite — verify before relying.
See our Terms of Use before relying on these notes. Report an error
Cases that cite this one
20 later published cases cite this decision.
- E. Edelman & Co. v. Queen Stove Works, Inc. (Minn. 1939)
- J. A. Campbell Co. v. Corley (Or. 1932)
- Skalsky v. Johnson (Minn. 1917)
- McCree & Company v. State (Minn. 1958)
- Mountain Iron & Supply Co. v. Braden (District Court, D. Kansas 1929)
- Gary Coast Agency, Inc. v. Lawrey (Or. 1921)
- Ehrsam v. Brown (Kan. 1907)
- Holt v. Sims (Minn. 1905)
- Reynolds v. General Electric Co. (8th Cir. 1905)
- Kinkel v. Winne (Kan. 1903)
- Wisconsin Red Pressed-Brick Co. v. Hood (Minn. 1895)
- Wisconsin Red Pressed-Brick Co. v. Hood (Minn. 1893)
- Schaffner v. National Supply Co. (W. Va. 1917)
- Stanford v. National Drill & Mfg. Co. (Okla. 1911)
- F. H. Gilcrest Lumber Co. v. Wilson (Neb. 1909)
- Crankshaw v. Schweizer Manufacturing Co. (Ga. Ct. App. 1907)
- Haines, Jones & Cadbury Co. v. Young (Pa. Super. Ct. 1900)
- J. Thompson Manufacturing Co. v. Gunderson (Wis. 1900)
- J. I. Case Plow Works v. Niles & Scott Co. (Wis. 1895)
- Milwaukee Boiler Co. v. Duncan (Wis. 1894)
This list shows which later cases cite this one. It does not say how they treated it, and no review of that has been done. Not a substitute for Shepard’s or KeyCite — verify before relying.
Opinion of the Court
The plaintiffs were manufacturers of and dealers in an earth-boring auger and appurtenances, known as the “Challenge Auger Outfit,” of which they had published and circulated descriptive catalogues, one of which they sent to defendant. This catalogue contained cuts or models of the outfit when put up and at work, and of the auger, and enumerated the various tools, etc., of which a full outfit consisted, which were stated to include “everything needed to bore a well, except wood-work for a derrick.” It also gave the prices of different sized augers up to 20 inches, and stated that plaintiffs could make to order larger sizes, if desired, but that they did not advise this, since a smaller one would answer all purposes, and that when it is required to make a large hole it was better to use a reamer. The catalogue further stated “these augers have been on the market too long, and are too well known, to need any lengthy explanation or guaranty on our part. We would simply say that our auger is designed to work in soft material only; and for a low-priced auger
It is not claimed but that, so far as the plan and make of the outfit is concerned, defendant got just what he ordered; but the complaint is that it did not and would not reasonably answer the purpose for which it was designed. There is certainly no express warranty contained either in the catalogue or the correspondence between the parties, all that was anywhere said about the kind of naaterial the auger was designed to work in, or the proper size, etc., being evidently merely precautionary or advisory. It is claimed, however, that there was, under the circumstances, an implied warranty that the article was reasonably fit for the use or purpose for which it was made and intended to be used, to wit, boring wells. As the contract was in writing, no warranty not expressed or implied by its terms can be added, either by implication of law or by parol proof.
Order affirmed.
Case-law data current through September 30, 2026. Source: CourtListener bulk data.