McFarland v. New York Cent. & H. R. Railroad
Opinion of the Court
Plaintiff attempted to couple car No. 7,609 of the Pittsburgh, Ft. Wayne & Chicago Company with car No. 5,388 of the Syracuse, Binghamton & New York Company. Before the evidence closed it appeared that car No. 5,388 was in a proper condition, and in response to a request of the defendant the court charged “that the defendant is not chargeable with negligence or
According to the testimony of the plaintiff he placed his left hand on the southeast corner of No. 7,609, and with his other hand reached over to put the pin into the hole of the drawbar, having adjusted the pin in the top of the hole so that it leaned back and was in a proper position to receive the link of No. 5,388 as it should enter the slit in the drawbar. He turned and placed his right hand on the southwest corner of No. 5,388, and, taking the link which was in the drawbar of that car in his left hand, guided it into the slit of the drawbar of No. 7,609, watching his hand, and watching the approaching drawbar, so as to properly make the coupling, and, after he had so guided the link, he let go of it, and undertook to remove his left hand, but the deadblocks came together, and his hand was caught between them. After the accident he discovered that the deadblocks, or bumper, on the east end of the car No. 7,609 was out of position,—that the same was not lengthwise of the sill, but it was in a diamond shape, so that one of its corners pointed towards the track. He also testified that the bolt which ran through the deadblock on the end of the sill was a little bent, and that the dead-block projected out four inches, so that it hung down four or five inches closer to the other bumper on the other car. He also testified that he did not see this deadblock until his hand was caught. He further testified that he did not see the drawhead of No. 7,609 until it was about a foot and a half from his hand. The witness Lester testifies somewhat differently in respect to the circumstances attending the accident, and he says that the cars came back
“The inside edgg of the deadblock on 7,609 is even with the outer edge of the drawbar. The distance from the bottom of the deadblock to the bottom of the sill, when the bottom of the deadblock is parallel with the track, is 2% inches. When the deadblock is turned in diamond shape, so that the point is nearest the track, the lower part of it is just at the bottom of the sill. It does not project below the bottom of the sill. The face of the dead-block is 12 inches, measuring parallel with the end sill. At right angles with that it is 7% inches. The deadblock on 7,609 projects beyond the end sill 5y2 inches. The distance from the bottom of the end sill to the top of the rail is 34% inches. The center of the drawbar ‘is 4 inches below the bottom of the end sill, and the bottom would be 8 inches below. * * * The drawbar is entirely under the body of the car, and below the end sill, excepting the face. The face projects above the bottom of the end sill about 1 inch.”
It was claimed by the plaintiff that the deadblock in question hung out, and he testified that the bolt which held it to the end sill was slightly bent, and that it stuck out about 4 inches, and that, as a consequence, the effect of that was to bring it that much closer to the other car. The witness Kosboth stated that it hung out an inch and a half.
It is apparent from the evidence that deadblocks vary in size and in- thickness. An examination of the evidence does not leave the impression upon" our minds that it warranted the jury in finding “that the plaintiff’s hand was caught solely because the buffer was in the position in which it was,” and that his hand “would not have been caught had the buffer been in its normal position.” Our attention is called to Goodrich v. Railroad Co., 116 N. Y. 398, 22 N. E. 397. We think the case differs quite essentially from the one in hand. In that case the evidence was very clear that, if the bumper had been in order, the accident would not have happened, and that the defective bumper was the proximate cause of the accident. In that case the bumper of the moving car was defective, and hung lower than it should have done, and if passed under the bumper of the stationary car, and permitted the deadwoods to come together; and upon that state of facts it was said that the defect in the bumper was the proximate cause of the accident. “The immediate effect was to permit the deadwoods of the two cars to come together, and the plaintiff was, from that cause, exposed to a danger not within the ordinary risks of his employment.” In that case it appeared very clearly that “the bumper of the moving car passed under the bumper of the stationary, car, and, in attempting to withdraw his hand, it was caught between the .deadwoods and severely crushed.”
In referring to the Goodrich Case in Arnold v. Canal Co., 125 N. Y. 17, 25 N. E. 1064, Judge Pinch says:
“In that ease the cars were being coupled for the purpose of proceeding on their journey. The plaintiff was required, in the nighttime, and with the aid of a lantern, to make the coupling, and found a broken drawhead, in seeking to use which his arm was crushed between the deadwoods.”
We are of the opinion that the evidence did not clearly indicate that the defects complained of were the proximate cause of the injuries received by the plaintiff. Upon that subject the evidence should be clear and persuasive, so that the jury should not be allowed or required to speculate as to the proximate cause of the injuries complained of. The conclusion already reached renders it unnecessary to consider some other grounds urged upon us in behalf of the appellant.
Order reversed, and a new trial ordered, with costs to abide the event. All concur.
Case-law data current through December 31, 2025. Source: CourtListener bulk data.