Koren v. National Conduit & Cable Co.
Opinion of the Court
The plaintiff, a man of middle'age, unable to speak English, a resident in this country for 16 years, was put to work by the .defendant operating a wire-drawing machine. By this machine wires were drawn out to a greater fineness, and much power was required for its operation. This power was transmitted from a revolving pulley near the ceiling to a pulley at the right end of the machine as the operator faced it, by means of a belt. Approximately midway between the pulley at the ceiling and the one at the machine, the belt was made to cross upon itself, presenting somewhat the appearance of an X, and by means of which the two pulleys moving in the same plane revolved in opposite directions. The belting ■came from the ceiling at an angle of approximately 45 degrees, and the machine pulley revolved in the direction of the movement of the hands of a watch, as one might look at it from a point opposite the •end of the machine. This arrangement created an open space at the end of the machine in the vertical plane bounded by belting and pulley nearly in the shape of an isosceles triangle, whose base was "between 1 foot and 18 inches and whose altitude was about 2 feet. •On the same axis with this machine pulley, further out, was fixed another precisely similar, except that its hub was always loose on the .axis or shaft, with the result that when the moving belt passed around the rigid pulley the machine operated, but when around the loose one it was at rest. For the purpose of transferring the belt from the tight to the loose pulley and back, there is a device known as a “belt -shifter,” whose use is attended with no danger whatever. The evidence shows that in wire-drawing machines throughout the country the almost universal practice is to supply pulleys of this character with "belt shifters. This machine was not equipped with a belt shifter. The plaintiff had no trade, but had worked around factories for al
“The foreman took me to the machine, and showed me the wire—how the wire ran through the machine, and then on the other end he showed me the wire winds around on a big thing like a wheel; and it winds around that. Then he showed me how the belt works, and he told me, when I stop work, to throw the belt off at six o’clock. Q. Did the foreman put the belt ■off and on in showing you how to do it? A. He took a piece of board about two inches wide, and showed me to pull to myself, towards me, and pull the belt off on the loose pulley. * * * Q. What did he do in showing you how to start the machinery? A. He took the stick, and showed me to pull it off or pull it down when I wanted it to run. Q. In showing you how to stop the machinery, did he pull the belt with the stick towards him? A. He showed me how to stop and how to start, and stepping towards himself he pulled the belt off, and running the machine put its on from him [sic]. * * * I did just as the foreman had showed me how to do when I wanted to stop the machine. * * * At the time I was injured I proceeded to stop the machine just as the foreman had told me to do, and how to do it. When T had the stick on the far side, I only remember when the stick was caught from me, I was pulled in and pulled out, and that is all I remember.” On cross-examination he testified: “When I shifted the belt, I put a stick against it and pressed.”
This is the only evidence in the plaintiff’s case as to what his instructions were, or the manner in which he was hurt. Had the defendant rested its case at this point, there might have been another question here, but defendant’s witnesses supplied evidence of the' manner in which the accident occurred. They testified that the plaintiff, standing opposite the pulley, and facing it, put his left arm into and through the triangular space described above, and the right arm over the upper segment of the belt, grasping each end of a small stick for the purpose of pulling the belt from the tight to the loose pulley. While he was engaged in that effort, the witness says: “Where the belt is sewed there, I suppose it picked his stick. I see him go around down to the floor.” From the nature of the injuries to his left arm, it must be assumed that it was caught in some manner between the upper segment of the belt and the surface of the pulley. The foreman testified that putting the arm through the space described is very dangerous, but that little danger attended moving the belt if the arm was not inserted there. The plaintiff says he was making the shift, at the time he was hurt, just as the foreman had instructed him. The foreman denies telling him to insert his arm into that dangerous space. The defendant moved to dismiss the complaint at the end of the plaintiff’s case, and again at the close, of the evidence. These motions were denied, and the case submitted to the jury, who found for the plaintiff, and the defendant’s motion for a new trial was denied.
The chief question of fact in this case is whether the foreman gave the plaintiff the instructions he states, and this question was fully
We have examined the other exceptions in the case, and are of the opinion that they present no substantial error.
The judgment and order appealed from should be affirmed, with costs. All concur.
Case-law data current through December 31, 2025. Source: CourtListener bulk data.