Krueger v. Bartholomay Brewing Co.
Opinion of the Court
It is conceded that plaintiff’s intestate, while in; the employ of defendant in February, 1901, met his death as the result of the bursting or parting at its joints of a large steam “ header ” or reservoir used in the latter’s brewery. It is assumed in the brief of defendant’s counsel, as it apparently was upon the trial, that the immediate cause of death was the- inhalation of the steam which was permitted to escape by reason of this rupture. A ■ coemployee of the intestate working near him was killed at the same time, and no surviving eye-witness of the accident was left.
It was and is claimed by plaintiff that this header was not only defective and unsafe in its original construction but that its strength and efficiency had become still further impaired at the time of -the casualty as the result of water and isteam escaping at its joints. In granting the motion of nonsuit the learned trial justice, by his remarks perhaps indicated his doubts of the negligence of the. defendant. He placed his decision, however, more especially upon the grounds that intestate assumed! any risks incident to the '-situatian and that plaintiff through her inability to produce direct testimony as to the immediate cause and surroundings of the accident did not successfully meet the necessary burden of showing that her intestate was free from contributory negligence. We are unable to agree with these views'.-and with the result to which they lead, but. think that the case should have been submitted to the jury.
Defendant was the owner of three breweries in the city of Rochester: In the one in question it had a battery of six boilers, three of 250 horse power each and three of 75 horse power each. The header which burst or parted was designed for the reception and accumulation and subsequent distribution of the steam from these boilers. It was constructed in 1892, and consisted of a large cylinder of extra heavy wrought iron about nineteen feet long and sixteen inches in diameter. It was divided into four sections, and the joints were made by screwing these sections into heavy cast, iron Ts. It was at one of the middle joints thus formed that the part
At about seven o’clock of the day of the accident intestate was directed to go into the engine room and calk the joints of the header to prevent the leakage of steam or water. At the same time another employee was sent into the same room to plug or unplug a dead boiler. At about half-past ten the attention of other employees in other parts of the brewery was attracted by the noise of escaping steam, and after the same had been shut off it was found that the header had burst as already stated, and intestate was found upon the floor some twelve or fifteen feet away from the broken joint and the other employee was found some distance in the opposite direction. One was dead at the time and the other one was unconscious and lived only a short while.
We shall take up first the issue of defendant’s negligence. There is no dispute that the header improperly parted, and that as the result thereof plaintiff’s intestate met his death. The only question is whether it could be said that this casualty was the result of an accident unavoidable and not to have been foreseen or anticipated by defendant, or whether it was the result of causes and defects of which defendant knew or ought to have known and against which it should have guarded and protected the lives of its employees. In adopting the conclusion that the latter is the true proposition, we
We direct our attention first to the manner in which the section of the cylinder was screwed into the T at the broken joint. The screw upon the end of the section consisted of twenty-one or twenty-two threads covering a distance of about two and three-quarters or three inches. It was screwed into the T to the- extent of only about eight or nine threads or- for a distance of about an inch and a quarter. If the joint were properly made the strength- and power of resistance there would be as great as at the middle or any other place in the section. The efficiency and strength of the joint would be directly-in-proportion to the number of threads by which the section was screwed into the T. We discover no dispute in the evidence that under the circumstances this ought to have been for a distance of abolit two and three-quarters inches .instead of for á distance of about one and one-quarter inches. The boilers were adjusted to blow off at ninety pounds, and the pressure of accumulated steam upon this cylinder was necessarily very great, and as a matter , of common experience and common judgment as well as in the light of the expert testimony which was given upon the subject we think it was permissible for a jury to say that it was not proper to make and leave this joint of eight or nine threads instead of double that number. A jury without any expert testimony would know that this section would much more easily pull out of the T when it was screwed in to the extent of only eight or. nine threads than it could have done if screwed in for double that number.
We have referred to the fact that steam was conducted from the boilers into the header in such ¡a manner as -to permit water to accumulate in the latter. For about a year after - the structure was put in the steam and water continually leaked at the jóints and nothing was done to tighten the latter. At the-end of that period the joints were calked with lead on the outside and-were also repaired in some- way by a boy crawling in through the pipe. Several months after ■ the original construction, pipes known as “ bleeders ” were run into the header at different points for the purpose of drawing off the acc'umulated water and thereafter the leakage of water at the joints was materially reduced although it did occur to some extent. After the pipes were repaired at the end
There does not seem to be any dispute that the leakage of steam and water at one of these joints would have an injurious effect upon the iron and upon the threads of the screw, the extent of injury, of course, being proportionate to the extent and continuation of the leakage. The steam would cut or “ eat ” the thread and the water would tend to affect or corrode the iron.
Coming to the joint in question, it is earnestly urged by defendant’s counsel that the water could not have had such an effect upon the thread, because if the iron had become corroded all the thread would have crumbled off and disappeared. The evidence of one of the witnesses who examined the joint after the accident was to the effect that the iron was discolored, and that the edges of the thread instead of being sharp and perfect were rounded off and somewhat bent. So that it seems to us that, whether as the result of these edges being eaten off by the steam or having been affected by the leakage of water, the jury had a right to find that the thread had become impaired and its strength and power of resistance to the pressure of steam diminished and the accident and pulling apart made easier. This-joint might have been so made that it would be as strong as any other part of the cylinder. The pressure of steam from the boilers was limited and the cylinder itself was heavy enough and strong enough to bear several times any pressure which could possibly be put upon it from the boilers as they were adjusted, This joint did not stand the pressure as it might and should have
If we are right in this conclusion we have little difficulty in reaching the further one that the jury might have found defendant chargeable with knowledge of and responsibility for the condition of the joint. It is urged by its counsel that this appliance was put in the brewery by independent contractors of established standing and reputation and that, therefore;, defendant had a right to accept and rely upon their construction. We fail to find in the evidence, however, any sufficient basis for this argument. The defendant did ' hire some men to put up the header, but the latter disclaim responsibility for its location, and at the time the joint in' question was made in the brewery defendant’s chief engineer was present and saw the work done and, both by his observation then and later of the thread upon the joint after the union had been made, must have known that the section was screwed into the T for less than half of the proper distance. Defendant, in the exercise of ordinary care, was not only bound to know of the subsequent leakage of. joints but the evidence clearly discloses that it did know' it.' Further than this, two tests were described upon the trial, known, respectively, as the hydrostatic and the hammer test, which it is said would have' disclosed any defective condition of the iron, and neither of which was made.
Therefore, we think that it was for the jury to say whether the defendant used a proper degree of care and caution in the construction and maintenance of this header, and we pass to a review of the other issues presented.
In determining questions of assumed risks and contributory neg- . ligence, the trial justice seemed to have in mind that calking the joint might have had something to do with this accident, and that plaintiff in part at least was basing her claim upon the theory that the intestate in that respect had been placed in a dangerous line of duty which led up to his death.
We do not think that plaintiff asked or was entitled to succeed
In reference to the question of contributory negligence, while there was no direct evidence to show just what intestate and his coemployee were doing at the time the pipe parted, we still think there was sufficient testimony to enable a jury to say that the deceased was free from any negligent act which contributed to or brought about his accident and the resulting death.
As already stated, he was found several feet from the bursted header, and very possibly,' as suggested, he was not actually at work calking the joint when the explosion took place. It is undisputed,
. It is finally contended that intestate was employed by defendant for another purpose than calking pipes; that he was not called upon or authorized to go where he did, but was a mere volunteer for whose misfortunes under the circumstances the defendant is not responsible. In opposition to this contention the evidence shows that various employees were called! upon to calk this header when it leaked; that intestate had been sent to do it once before, and that upon this occasion.instructions were given to him to again perform this work by defendant’s chief engineer or superintendent, who appears to have been fully empowered to give such orders. Under the circumstances, we think that defendant, through its representative, having sent the intestate to do this work, cannot successfully claim -that it was free from any obligations to him as an employee while he was engaged in discharging his duty.
The case of Franck v. American Tartar Co. (91 App. Div. 571; 87 N. Y. Supp. 219) presents some features similar to those
The judgment and order should be reversed and a new trial granted.
All concurred, except Stover, J., who dissented.
Judgment and order reversed and new trial ordered, with costs to the appellant to abide event.
Case-law data current through December 31, 2025. Source: CourtListener bulk data.